Does WRT54G work without DHCP on?

Discussion in 'Cisco/Linksys Wireless Routers' started by JoeJoe, Jul 30, 2004.

  1. JoeJoe

    JoeJoe Network Guru Member

    I just purchased a WRT54G. It had Firmware 2.02 and I could not get the wireless to work. I flashed to 2.04.3 and wireless worked. I am trying to get the wireless to work with DHCP turned off. Is this possible? The Router IP was set to 192.168.10.1 Subnet was set to 255.255.255.192. I set my desktop to 192.168.10.5 and it works with the CAT5 cable. I set my laptop to 192.168.10.3 and another desktop to 192.168.10.4 and neither one will see the router. Gateway for both wireless cards is 192.168.10.1 DHCP is turned off. Any ideas?

    Thanks,

    Joe
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice