1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

DynDNS any tutorials?

Discussion in 'Tomato Firmware' started by kardzzz, Oct 24, 2010.

  1. kardzzz

    kardzzz Addicted to LI Member

    Guys,
    I setup a DynDNS free account, setup my Tomato (Victek 1.25.xxx).

    When I input the DNS addess to a browser, it doesn't connect to anythng.
    Did I miss a step in the port forwarding?

    I want the DNS address to point to my NAS box for ftp/web hosting services.

    I'm sure I had this working before either on Tomato or ddwrt.
    thx
     
  2. LanceMoreland

    LanceMoreland Network Guru Member

    DynDNS will forward to your IP. You need to set your router to forward to various ports for ftp, remote desktop or whatever it is you are trying to reach. Then if you are using an ftp client it will be detected and contact the drive you have set up for ftp. You can also use a colon with the port number on the end of the address, for example, I set up to remote desktop to multiple clients on my network so they need to all accept a remote desktop connection at different ports. This would look like: your.DynDNS.address.com:xxxxx where xxxxx is the port of the client you are trying to reach.
     
  3. neilph

    neilph Networkin' Nut Member

    its better to post screen shot setup.
     
  4. srouquette

    srouquette Network Guru Member

    did you forward the ports ?
     
  5. Toastman

    Toastman Super Moderator Staff Member Member

    I'm sure you got this right, but for any newcomers doing this and trying to connect to your router's GUI, don't forget to enable remote access and then it's http://myaccount.dyndns.org:8080 to reach it.
     

Share This Page