1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

e3000 bridge mode set up?

Discussion in 'Tomato Firmware' started by seginus, Jan 19, 2012.

  1. seginus

    seginus Networkin' Nut Member

    Hi. New poster here and I have some (a little) knowledge on this stuff. Bear with me on some misspoken terminology. Hoping you all could give me some advice on a desired set up.

    My current set up is as follows: E4200 (2nd floor)=>MOCA adapters=>dd-wrt'd WRT54G bridge mode(basement)=>wired connection to PS3/Xbox/TV/STB, etc. Works fine as is but want to get the dual band e3000 in the basement.

    I want to do pretty much the same thing but with the e3000 in place of the WRT54G. I do want G only on 2.4 and N only on 5 duplicating what I have set up on the E4200.

    I tried setting it up already but obviously things were different dd-wrt v tomato (a current victek build) and things didn't quite work out. I flashed to tomato as I used tomato for another wireless bridge (e2000) I set up in my bedroom for DirecTV whole home DVR which works great.

    Really appreciate any help!

Share This Page