E3000 Power blinking

Discussion in 'Cisco/Linksys Wireless Routers' started by Armin Forum, Sep 26, 2011.

  1. Armin Forum

    Armin Forum Networkin' Nut Member

    Hello
    I am working on an E3000 wireless router.the first time i turned it on it booted up fine and i was able to access the setup,but after a few minutes i lost communication to the router and couldn't ping it.
    after that,when i power cycle the router, the power LED just blinks and i can't ping the router. I tried reseting the router and serveral reset methods.such as holding the reset power for 30 seconds then releasing it,hard reset and so on,but so far no luck. Is there anything i can do about it or the router is faulty and needs to be replaced?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice