Editting NVRAM

Discussion in 'DD-WRT Firmware' started by 8ball, Aug 1, 2005.

  1. 8ball

    8ball Network Guru Member

    Possible Noob question:

    Is there a way to edit or remove a line in the nvram, possible like vi, or do I have to just use the reset button to erase it and start over again. I would like to modify a port in my iptables entry and I'm not sure if there is an easy way to do this without erasing it and starting again. I see lots of command examples for adding lines for is there one for removing a line?
     
  2. Thibor

    Thibor Super Moderator Staff Member Member

    it's quite simple really
    all you need is "nvram unset blah" to remove a line, and then nvram commit to save the changes
     
  3. 8ball

    8ball Network Guru Member

    ahhh thank you greatly!! I'm a cisco person so I was trying "nvram no set"

    Sometimes it's sitting right in front of you. Thanx
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice