ENTWARE Repos with Shibby's v132 + Asus router

Discussion in 'Tomato Firmware' started by jenom, May 17, 2018 at 11:12 PM.

  1. jenom

    jenom Addicted to LI Member

    Installed ENTWARE on a Asus RT-N66U router with Shibby's Tomato v.1.32
    All went well without any issue, did "opkg update/opkg upgrade at the end.
    Entware used repo "http://old.entware.net/binaries/entware" as specified in
    /opt/etc/opkg.conf.......src/gz entware http://old.entware.net/binaries/entware

    However, this repo did not have a pkg I was looking for, but after a little research found repo
    http://pkg.entware.net/binaries/mipsel, and I changed:
    /opt/etc/opkg.conf..... src/gz entware http://pkg.entware.net/binaries/mipsel

    Reboot/ opkg update resulted a long list of the following complaints:

    Package aspell version 0.60.6.1-1a has no valid architecture, ignoring.
    Package asterisk11 version 11.25.3-1 has no valid architecture, ignoring.
    Package asterisk11-app-alarmreceiver version 11.25.3-1 has no valid architecture, ignoring.
    Package asterisk11-app-authenticate version 11.25.3-1 has no valid architecture, ignoring.
    Package asterisk11-app-chanisavail version 11.25.3-1 has no valid architecture, ignoring.
    Package asterisk11-app-chanspy version 11.25.3-1 has no valid architecture, ignoring.
    Package asterisk11-app-confbridge version 11.25.3-1 has no valid architecture, ignoring.
    and so on.......

    Question:
    Is the "mipsel" correct for Asus RT-N66U ?
    If not, what should I use from http://pkg.entware.net/binaries ?

    Thanks!
     
  2. koitsu

    koitsu Network Guru Member

  3. pomidor1

    pomidor1 Networkin' Nut Member

  4. maurer

    maurer LI Guru Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice