Firmware for Wrt54G V 3.1

Discussion in 'Sveasoft Firmware' started by fmarius, Sep 12, 2005.

  1. fmarius

    fmarius Network Guru Member

    i was using the Alchemy v1.0 on previous versions of wrt54g hardware, but this week i bought the V3.1 version, and when i tried to flash it with alchemy 1.0 i get the message " UPGRADE FAIL".

    What Firmware can i use for WRT54G V3.1 ???

    i need WDS and Client mode on it


    - thanks - :sadbye:
     
  2. Disman_ca

    Disman_ca Super Moderator Staff Member Member

  3. fmarius

    fmarius Network Guru Member

    thanks ... i will try it !
     
  4. fmarius

    fmarius Network Guru Member

    nope ... i still get the UPGRADE FAIL messege
    -- i am using a wrt54g not wrt54gs, the firmware is for wrt with speed booster :thumbdown:

    -- so i`m asking for help again : the hardware version of router is v. 3.1

    and the original firmwarer version is : v4.01.1
     
  5. fmarius

    fmarius Network Guru Member

    after a lot of digging i have found the solution :

    http://www.linksysinfo.org/modules.php?name=Forums&file=posting&mode=quote&p=17200

    ..So I bought new WRT54G.
    v3.1, FW v4.01.1
    'cause I need Client mode, I tried first Sveasoft Alchemy: upgrade failed.
    Then I put HyperWRT 2.1b1 - OK but it has no client mode.
    Box says that it is FW v.3.03.6
    THEN i "updated" to Sveasoft Alchemy, now it says about itself
    Firmware version: Alchemy-6.0-RC5a v3.01.3.8sv
    It has client mode and power adjustment, as you needed.

    ..... thanks kiilakas

    [marq=right:0c0366c880][/marq:0c0366c880]
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice