1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

First Time Loading Hyperwrt Firmware

Discussion in 'HyperWRT Firmware' started by POSTALONE, Sep 22, 2006.

  1. POSTALONE

    POSTALONE LI Guru Member

    I am familiar with upgrading the firmware using the standard Linksys versions. one of the features of the Linksys upgrade is that all of your stored settings/ password / SSID info remains. Will I have to start from scratch once I load HyperWRT firmware? :thumbup:
     
  2. Toxic

    Toxic Administrator Staff Member

    it is best too simply as there are new nvram settings in Thibor15c than the default linksys one.

    the settings should remain, but you may get incompatabilities and problems later on.

    it is better to clear the nvram and factory reset the router once the firmware upgrade has taken place.
     
  3. redsandvb

    redsandvb Network Guru Member

    How about when upgrading from 15b to 15c?

    Thanks!
     
  4. slamcat

    slamcat Network Guru Member

    If you're upgrading from the same firmware set, typically not resetting the NVRAM won't hurt.

    But resetting it won't hurt either, and I prefer to do that, even if it means me spending five minutes setting back up.
     
  5. redsandvb

    redsandvb Network Guru Member

    Thanks.
     

Share This Page