Flashing Power and Diag Lights on WRT54G v1?

Discussion in 'Cisco/Linksys Wireless Routers' started by GMFreak8, May 1, 2007.

  1. GMFreak8

    GMFreak8 Guest

    I tried updating the firmware on my linksys wrt54g v1 earlier last night, and after the firmware loaded (it said it was successful), the power and diag lights started to flash. It doesn't recognize that there's a computer connected to it, the only lights that do anything are the power and diag lights. They just keep flashing about once per second. It's not the rapid flashing that's associated with a reboot. If I keep trying to hold down the reset button and disconnecting and reconnecting the power, it sometimes will boot normally, but then the power and Diag lights begin to flash slowly again. Does anyone have any clue what this could mean? Is it hardware related or firmware related? Any help would be appreciated. Thanks.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice