Force 10mbps on WAN port?

Discussion in 'Cisco/Linksys Wireless Routers' started by jdevan00, Apr 16, 2006.

  1. jdevan00

    jdevan00 LI Guru Member

    I tried searching and didnt find anything so:

    Anyone know if i can force the WAN port on my new WRT54G v4 to 10mbps? My old linksys (802.11b) router detected at 10mbps automatically. I have the standard unmodded firmware 4.20.6.

    Background:

    My cable modem is upstairs and I have a sketchy ethernet cable that only works on 10mbps running from the modem to the router. The router is downstairs in a room with 3 wired pc's.

    Thanks in advance.
     
  2. jdevan00

    jdevan00 LI Guru Member

    I'd like to leave the linksys firmware for now. Can I do anything with the ping.asp hack and exec a command like "admcfg port0 10Mbps"?

    Or is that only possible if I have 3rd party FW?
     
  3. Toxic

    Toxic Administrator Staff Member

    a third party firmware should allow to to set this via Telnet.
     
  4. crawdaddy

    crawdaddy Network Guru Member

    I didn't ever realize that the wan port is capabable of 100mbit, then again, why wouldn't it....
     
  5. jdevan00

    jdevan00 LI Guru Member

    which would you recommend? im sure there is a large discussion on preference but this is the only additional functionality i'll need. I need one that works well with bit torrent.

    thanks
     
  6. Toxic

    Toxic Administrator Staff Member

    Thibor's HyperWRT or DDWRT
     
  7. jdevan00

    jdevan00 LI Guru Member

    thanks for the help. I ended up re-crimping to T568B. That seems to have fixed the prob.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice