1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

fresh flash, can't change DHCP

Discussion in 'Tomato Firmware' started by vivithemage, Nov 10, 2012.

  1. vivithemage

    vivithemage Serious Server Member

    I have a E4200 V1, running : Tomato Firmware v1.28.0500 MIPSR2Toastman-RT-N K26 USB VLAN-VPN

    I just installed it and went to change the IP DHCP pool and it says :

    Cannot proceed: two or more LAN bridges have conflicting IP addresses or overlapping subnets

    I also get that when I just try disabling the wireless in that BASIC/NETWORKING section.
     
  2. gfunkdave

    gfunkdave LI Guru Member

    The error you're getting is pretty clear: changing the DHCP pool is resulting in conflicting IP address ranges.
     
  3. vivithemage

    vivithemage Serious Server Member

    That is what I thought, but I tried different subnets, 10.10.5.x and 10.10.10.x, and even what it is now ... 192.168.1.x it still errors out on me. This is after a reflash from the linksys firmware, why would it pop up and what do I have to change to make it work?
     
  4. Porter

    Porter LI Guru Member

    Could it be that you forgot to erase your NVRAM after the firmware change?
     
  5. vivithemage

    vivithemage Serious Server Member

    Can I clear it now? or will that cause an issue?
     
  6. Porter

    Porter LI Guru Member

    Ok, then you should have cleared it in the first place. Do it now. All your settings will be lost.
     
  7. vivithemage

    vivithemage Serious Server Member

    That is fine, if I clear it does it go 'stock'?
     
  8. Porter

    Porter LI Guru Member

    The settings will revert to the defaults. The firmware you have flashed will stay on there.
     
  9. vivithemage

    vivithemage Serious Server Member

    will try, thanks.
     

Share This Page