1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

From DD-WRT to Tomato

Discussion in 'Tomato Firmware' started by PGalati, Oct 2, 2006.

  1. PGalati

    PGalati Network Guru Member

    It appears that I successfully installed the .5 Tomato firmware but am unable to access the admin GUI now. My old DD-WRT username and password is not working. Was there a username or password change when the installation took place? I did not perform a hard reset yet. If I did, would I be using the original Linksys username and password or the DD-WRT username and password? Does Tomato create it's own username and password for hard resets?

    Unfortunately, everything decompressed fine except the readme.htm, so I am unable to access that file for reference.

    TIA.
     
  2. GoldServe

    GoldServe Network Guru Member

    Hold down the reset button for more than 20 seconds to complete restore the NVRAM. The dd-wrt admin user and pass values were stored as encrypted so that is why it does not work anymore.
     
  3. dvaskelis

    dvaskelis Network Guru Member

    From the README:
     
  4. njeske

    njeske Network Guru Member

    read the readme file. you have to use "admin" as the username now.
     

Share This Page