fss2 appears to be READ ONLY!

Discussion in 'DD-WRT Firmware' started by oninous, May 7, 2008.

  1. oninous

    oninous Addicted to LI Member

    jffs2 appears to be READ ONLY!

    I have this reported in the DD-WRT web interface;
    (jffs2)

    Total / Free Size 256.00 KB / 0

    It either appears that fss2 itself takes up all 256KB of extra flash space or something is misconfigured. Any ideas? I didn't think fss2 itself was so big... I actually downgraded the firmware so I could have more space for fss2 but did I not downgrade enough??!! Please help and thank you for reading!
     
  2. mstombs

    mstombs Network Guru Member

    Not used under dd-wrt but jffs does need a big amount of memory for itself. If your firmware much bigger than 3MB in a 4 MB flash quite likely there is no room. Under Tomato on an 8MB flash router I have 176kB of files but am losing 0.5MB to the format

    Code:
    Total / Free Size	4,992.00 KB / 4,288.00 KB
     
  3. oninous

    oninous Addicted to LI Member

    Ah OK! It's useless to me (accept for mapping to SD Card) until I upgrade my WRT54GL's flash chip then! Which I won't do until i do my dual-serial and JTAG mods. I'm a lil confused about JTAG however. Like what connector does it use.. Serial? or does it use it's own connector?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice