fwbuilder help

Discussion in 'DD-WRT Firmware' started by zgamer, May 9, 2005.

  1. zgamer

    zgamer Network Guru Member

    In an attempt to use fwbuilder I managed to make the router very secure.....locked myself out of it. In hopes that I don't do it again can anyone post a working ruleset?
  2. on4cet

    on4cet Network Guru Member

    I asked the same question before ... and somebody was willing to post it, but haven't seen it yet ...

    I'm afraid too, to lock myself out ...

    We'll see ... maybe this should act as a wake-up call ... to remind the fact that there are users who are willing to use the iptables in combination with the fwbuilder program ...


  3. zgamer

    zgamer Network Guru Member

    I ended up holding the reset button on the back of the router which reset the firewall ruleset to the firmware defaults :)
  4. tl511

    tl511 Network Guru Member

    If you use the default setup for a sveasoft/linksys router it will allow access to the firewall automatically. You have to allow internal network(s) to the firewall on port 22 and 80. Let me see if I can get a screen shot of my global rules.

  5. on4cet

    on4cet Network Guru Member

    This is kind of what I wanted ... But I use DD-WRT, are these interfaces still the same ... I mean vlan0, vlan1, br0 etc ... ?


    Any others out there with config for DD-WRT ?
  6. zgamer

    zgamer Network Guru Member

    It should work fine as dd-wrt was based off sveasoft's alchemy code.

    more so I would like to see something like what fwbuilder has as an addon for the web-interface on dd-wrt but that's beyond my programming knowledge.
  7. thedogcow

    thedogcow Network Guru Member

    I don't suppose anyone has a picture of a working policy as mine doesnt work properly :(
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice