1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

general question about hard reset - 4 different ways?

Discussion in 'General Discussion' started by xer47, Jul 2, 2006.

Thread Status:
Not open for further replies.
  1. xer47

    xer47 LI Guru Member

    Hi, I was trying to find the right way of doing hard reset after firmware update and it looks like no1 know the correct way of doing it, or at least there are 4 different ways:

    1. The one Linksys tell you to do in the manual:

    Without turning off router, disregarding all the leds just push and hold the reset button for 30 seconds.

    2. The one Linksys tells you to do if you call them and say their manuals suck:
    Without turning off router, push and hold the reset button for 30 seconds, then unplug the power cord for 10 seconds, and keeping the reset button, then plug the power cord back and release the button


    3.The one Linksys tells you to while you call second time and say their manuals suck and they have retarded CSRs:
    Without turning off router, push and hold the reset button for 30 seconds, then unplug the power cord for 10 seconds, and release the reset button(!!!), then plug the power cord back in 10 sec.

    4. And finally the one I got from http://www.hyperwrt.org:

    Unplug the power cord of the wireless router(!!!). Hold down the reset button for 30 seconds, then, plug in the wireless router (power cord) while continuing to hold that reset button nonstop for the next 10 seconds.




    Now, maybe Im stupid, but there is something wrong here and I would like to know which one is wrong. :rofl:
     
  2. Esquire

    Esquire Mesquire Staff Member Member

Thread Status:
Not open for further replies.

Share This Page