geting Dead Wap54g Alive Ways:idea:(let us know if u know)

Discussion in 'Other Linksys Equipment' started by onlineemails, Apr 5, 2005.

  1. onlineemails

    onlineemails Network Guru Member

    Hi i had a Wap54gv2 with fireware v2.08 because of ap_client mode problem i downgrade it to 1.08. when i restarted The ap it didnt worked. my i can give it to gruanty But i dont wana do this is there any ways to solve that problem. Please Write Them For All THANXSSSSSSSSSSSSSSSS U ALLLLLLLLLLLLLL[hr:9525d8dead] :idea:
  2. wifistiens

    wifistiens Network Guru Member

  3. t4thfavor

    t4thfavor Network Guru Member

    there are quite a few ways. one is to set up a pc with ping -t Router ip
    and then ping it. reboot the router if it starts recieving pings for a few seconds (or 5 pings) then you are in luck.
    look up how to tftp the fw into the router and then do the same thing (ping) except this time as soon as it starts recieving pings send the tftp.

    this way only works when ( i believe) you have 3rd party firmware already installed but you can try it

    next is look for the flash chip inside that says intel. short pins 15 and 16?? while pinging it and powering it on..... and then you should be able to upload new firmare

    i know that is already stated in that website from the other poster but it was in german...

    good luck
  4. wifistiens

    wifistiens Network Guru Member

    That's not German , it's Dutch ;-)
  5. Avenger20

    Avenger20 Network Guru Member

    Idd. Will translate it to English and put it in the HyperWAP manual ;)
  6. wifistiens

    wifistiens Network Guru Member

    Funny cause I translated it to Dutch from a English post on this same website :)
  7. wifistiens

    wifistiens Network Guru Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice