Giving a public IP address to one device

Discussion in 'Tomato Firmware' started by menses, Jan 20, 2014.

  1. menses

    menses LI Guru Member

    I have a very basic setup where my Asus WL-500W acts as a router for all my devices and connects them to the Internet. Basically everything just works with the default Tomato (Shibby) settings.

    However now I would like to assign another public IP address to one of my devices which connects via ethernet to the Asus. How to accomplish this? I would still like to connect to the device from the internal LAN so it should also have a private IP address. My ISP provides me with at least two public IPv4 addresses (DHCP).
     
  2. darkknight93

    darkknight93 Networkin' Nut Member

    you can achieve that by Advanced -> VLAN -> pick one port an Bridge it to vlan2 instead of br0. On this port the device is excluded from your Network and directly connected to your WAN device/Gateway

    BUT: you will not be able to contact your local devices anymore despite you use tagged vlans (search for explanations online) or using 2 NICs in your end device
     
  3. lancethepants

    lancethepants Network Guru Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice