1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

GS(client mode) connected to switch ??

Discussion in 'Sveasoft Firmware' started by raptor, Sep 21, 2004.

  1. raptor

    raptor Network Guru Member


    I have the following config :

    wrt54gs  (lan1) ---> switch -----> cable modem ---> Internet
                           |-----------> computer1
                           |-----------> computer2
    When I connect WRT to the switch after ~20sec my intertnet connection trought cable modem stops ??

    Any idea why this happens and how to solve it ?
  2. grcore

    grcore Network Guru Member

    The WRT can only handle 1 IP on the LAN side in client mode (with Satori). You would need to replace the switch with a router if you want more than 1 device.

    Or get the Alchemy release, which is only open to subscribers of Sveasoft (currently). Or wait till Alchemy gets released publically.

  3. raptor

    raptor Network Guru Member

    good, but why it blocks my internet access I have to restart (power) the cable modem to have internet back..
    why not only linksys blocks..!!
    Any technical explanation !
    Can something be done on the Satory4 with bridging/routing to workaround it...
    If now any way to connect two GS in some other mode, but not AP<->client, WDS ...

    Does WDS have the same problem.
    GS is router it seems very weird that it not support such configuration!!
  4. grcore

    grcore Network Guru Member

    I think I may have misunderstood your layout...

    How many IPs does your ISP give you?

    If its only 1, then you cant have three devices conencted to the cable modem.


Share This Page