1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Guest SSID setup

Discussion in 'Tomato Firmware' started by vladlink, May 24, 2012.

  1. vladlink Reformed Router

    Hi, I'm new here. Just got E3000 and flashed it with Victek Tomato
    (tomato-E3000USB-NVRAM60K-1.28.9007MIPSR2_RAF-VPN-NOCAT.bin)
    I'm just wondering if you can point me to a good step-by-step guide on setting up Guest SSID.
    Thanks a lot.
    vladlink, May 24, 2012
    #1

  2. Python46 Networkin' Nut

    Python46, May 24, 2012
    #2

  3. vladlink Reformed Router

    Thanks Python46.
    Unfortunately I couldn't find an option to create a new VLAN.
    I don't see the option for IP/MAC bandwidth limiter either.
    Is it because I'm not using the latest firmware 1.28.9011?
    vladlink, May 24, 2012
    #3

  4. Python46 Networkin' Nut

    That's possible. I have had good luck using 9011, but I have not set 'guest' up with it.
    Python46, May 24, 2012
    #4

  5. zapoqx Serious Server

    ya, you need to have 9010 I believe it is minimal for that and the post is 9011. But following the instructions is rather easy. Just becareful in setting up the guest ssid cause once you set it up and accidentally add another guess ssid, its permanently there.
    zapoqx, May 25, 2012
    #5

  6. vladlink Reformed Router

    Thanks guys. I flashed it with 9011 and managed to configure guest SSID following Teaman's instructions.
    It seems to be working fine. Now I'm trying to reset the Shared Key, but after I reboot the router, it sets it back to the
    original one. Does is mean you cannot change it at all?
    vladlink, May 26, 2012
    #6

Share This Page