1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

HDHomerun ARM build for Netgear R7000

Discussion in 'Tomato Firmware' started by 0007Rraegten, Jun 6, 2014.

  1. 0007Rraegten

    0007Rraegten Reformed Router Member

    I have a HDHomeRun from http://www.silicondust.com/products/hdhomerun/dvbt/

    I would like to use the tv tuner on the R7000, running
    Shibbys Tomato Firmware 1.28.0000 -119 K26ARM USB AIO-64K,
    to record to the attached usb3 drive.

    For this I need the hdhomerun_config build for ARM.

    What I did try:
    Install optware-devel
    Download and extracted the http://download.silicondust.com/hdhomerun/libhdhomerun_20140604.tgz
    Run make from the folder on the router
    It complained about missing gcc
    Found some gcc..._arm.ipk somewhere, but that install removed libc.so.6
    so I had to reinstall optware.

    I think this should be easy for the router to run, as hdhomerun_config is only used to
    setup the channel and where to save the stream, on the HDHomeRun.

    If you know where to get an ARM build of hdhomerun_config, please tell.
    Else if you can make a build of it for the R7000 and share it, then godspeed to you.
     
  2. lancethepants

    lancethepants Network Guru Member

    0007Rraegten likes this.
  3. 0007Rraegten

    0007Rraegten Reformed Router Member

    Great :) Thanks lancethepants, i'll test it and get back. Here we have no encryption on normal channels, so tv tuners like the HDHomerun is a hit :)
     
  4. 0007Rraegten

    0007Rraegten Reformed Router Member

    Last edited: Jun 6, 2014
  5. lancethepants

    lancethepants Network Guru Member

    Cool! glad it's working :)
     

Share This Page