1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

HELP! Default All Internet traffic to VPN Tunnel - RV042/RV082

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by rclsf1, Jan 5, 2009.

  1. rclsf1

    rclsf1 Addicted to LI Member

    Hi,

    Is there any way to have the remote clients to default ALL internet traffic to the VPN tunnel terminated at the central site using Linksys RV082/RV042?

    I have been trying to find out how to make all the VPN clients to default ALL of their internet traffic to VPN tunnel, but I couldn't get this functionality to work.

    Currently, the remote clients 'could' establish IPSec Tunnels to the central site or access any hosts at the central site (192.168.x.x) using "Client to Gateway" setup (not the QuickVPN).

    Using ShrewSoft VPN Client on XP, the remote clients could see the the default route 0.0.0.0/0 goes via VPN address and VPN interface (route print), but the remote client still could not access any Web site via the RV082/RV042 at the central site.

    This is a BIG black hole. But, DNS queries from the central site works. The remote client just could only reach any hosts (192.168.x.x) at central site.

    Using Linksys QuickVPN, the remote clients could access any Web sites, but not thru the VPN tunnel. Thru QuickVPN, the remote client is no longer default 0.0.0.0/0 to VPN interface, rather default to the local ISP DSL gateway.

    If anyone can shed light on how, I really appreciate it.

    Thanks,
    Rod
     
  2. DocLarge

    DocLarge Super Moderator Staff Member Member

    Simon,

    have you retired your RV042 completely since going CISCO at home?
     

Share This Page