Help Dummy, pls...!

Discussion in 'Cisco/Linksys Wireless Routers' started by roninjax, Mar 9, 2014.

  1. roninjax

    roninjax Reformed Router Member

    Confession: I find most network discussions too full of tech jargon to be useful, so I hope anyone responding to this post will go easy on me!

    I have a Medialink router in home, and hooked up my Linksys WRT-300n (V1.0) as a booster in my office. All was good until I lost the signal in the office and discovered a blinking power LED on the WRT.

    I did a hard reset (30-30-30) to no avail. After that, Linksys's troubleshooting guidance got too loopy for me, and seems to refer only to situations where theirs is the main - and only - router.

    Would someone please be kind enough to tell me how to get my WRT working again?

    TIA!
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice