1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help rfc 1483

Discussion in 'Other Linksys Equipment' started by acarlo, Nov 10, 2005.

  1. acarlo

    acarlo Network Guru Member

    I bought a wag354wg and my internet provider gave me 8 ip address.
    How i can setup this router to share these ip and to use in my lan private ip ?
    I know to loose 3 of these ip for lan broadcast and gateway but i would like to set something like static routing between 2 ip and 2 ip private and dynamic for all another ip.
    Is something possible with this router ? I have even one wrt54gs and even on this is looking not possible.
    Thanks for help.
  2. booly

    booly Network Guru Member

    You'll have to setup a custom routing table
  3. acarlo

    acarlo Network Guru Member

    I know this, but in static routing of linksys is looking that i can config a static rout to another router.
    I need to assign public ip addres to my private ip.
    If i'm giving one pubblic address to the router lan side how i can use private ip in my lan? Witch gateway i could use ?
    Really i would like know how to make this with linksys products.
    Where can i find few doc to read about this ? thanks.
  4. limesoft

    limesoft Network Guru Member


    Pitty, i have same problem as you facing b4, i tried to get linksys engineer to help me figure it out, but they can't help. I solve my problems using SMC7904BRA. It can handle 10 gobal ips(wan ip) forword to local ip. AND it also can do multiple DMZ!!
  5. acarlo

    acarlo Network Guru Member

    Thank i'l be looking so for the same product, really i was not waiting that linksys coudn't make so big mistake, i thin is very important future.
    I hope that will arrive in next firmware upgrades.
    Thanks alot
  6. limesoft

    limesoft Network Guru Member

    SMC7904BRA multi address mapping

    [​IMG]Multiple DMZ

Share This Page