1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

HELP!! Wireless WRT54GS bridging. (Routing Problem)

Discussion in 'Tomato Firmware' started by arian40, Feb 27, 2011.

  1. arian40

    arian40 Networkin' Nut Member

    Hi all.

    I have a WRT54GS which I have bridged wirelessly with my other router.
    I made both router to be in the same network
    example
    (R1 = 10.0.0.1 255.255.0.0 - R2 10.0.1.1 255.255.0.0)

    and it worked fine both routers connected but i read a few forums and from the experiance I had it was running slow and apparently if you put them on diffrent network and route them together it would work faster.

    so what i did was

    (R1 = 10.0.0.1 255.255.255.0 - R2 = 10.0.1.1 255.255.255.0)

    abviously they stopped communicating and Router(2) ? (I think) needed a route command but I do not know what the Destination and gateways and interfaces will be.

    Could some one please help me??

    I have also did a quick mockup of my network if it makes life easier.

    Thank you


    Arian
     

    Attached Files:

  2. TT76

    TT76 Networkin' Nut Member

    I don't think that would be helpful in speed. but if you wanna test it , do this. Setup R1 wireless mode to client and input R2 ssid and psa key, and then setup wan mode to static and assign a ip in the same subnet as R2 lan like 10.0.1.2 255.255.255.0. In addition, make sure checking that dhcp relay box.
     

Share This Page