Help with release and renew @ command line

Discussion in 'HyperWRT Firmware' started by SouthSko, Mar 22, 2006.

  1. SouthSko

    SouthSko Network Guru Member

    I'm not the best at linux and this router, but can someone help me and give me the command the status page uses to release and renew your ip? I know ipconfig in linux is different, but there is no ip config. Damn I suck. Anyway

    I am writing a script so when you push the ses button on the router the light goes off and it releases your ip on the DSL modem, then you press it again it renews the IP and turns on the light.

    Thanks.
     
  2. Thibor

    Thibor Super Moderator Staff Member Member

    ifconfig vlan1 down(takes the wan interface down)
    ifconfig vlan1 up(brings it back up)
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice