How to access router under AP+WDS mode?

Discussion in 'Tomato Firmware' started by wolfort, Mar 21, 2008.

  1. wolfort

    wolfort Guest

    tomato 1.17 firmware + WRT54g v3
    Router was set up into Access Point + WDS mode by mistake.

    The router's ip address before that was 192.168.1.1
    after that I can't access router by using the above address.

    My computer's usual IP was 192.168.1.XX
    now it's far from that address.

    What I should do so that I can access router again?
    Thanks!
     
  2. LLigetfa

    LLigetfa LI Guru Member

    Reset the router to defaults.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice