How to access subnetworks when one WRT54G is acting as a cli

Discussion in 'HyperWRT Firmware' started by raysmd, Apr 14, 2006.

  1. raysmd

    raysmd Network Guru Member

    How to access subnetworks when one WRT54G is acting as a client?


    I have the following setup. WRT54G-A is acting as an access point. WRT54G-B is acting as a client so that my Tivo can access the internet (ethernet only port).

    My computers all access the internet via WRT54G-A (the access point). Now, my Tivo is on a different subnet 192.168.3.202 whereas the PCs are on 192.168.1.10x


    Is there a way for them to all of them to see each other on the network? I tried to set up a WET but don't know exactly what that does.
     
  2. raysmd

    raysmd Network Guru Member

    ahh, figured it out. thanks anyway.


    My WET configuration was trying to use WPA2. I had to change it to WPA1.


    works great now.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice