1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

How to bind Multiple IPs on WAN RVL200

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by Autobahn97, Aug 28, 2007.

  1. Autobahn97

    Autobahn97 LI Guru Member

    I think this may be a simple question but I have an RVL200 running beta v1.1.5 firmware (I needed the fix to properly maintain source IP for all packets forwarded by the router). My ISP has issued me 2 IPs that I would like to bind to the WAN interface of the router so that I can set up forwarding differently based on WAN source IP. What I would want to do is terminate port 443 on 1 WAN source IP at the routers built in SSL VPN and forward 443 on the second WAN source IP the our internal Exchange webmail. Any advice is appreciated. currently the router is set up for DHCP which is the only way I have ever set these up. It always gets the same IP. I am afraid to 'play around' with the static setting as this is already production so I'm trying to get as much info as possibly before changing the config.
     
  2. ifican

    ifican Network Guru Member

    I have never seen the gui of an rvl so unless it has a special feature there is no way to assign 2 ip's to a single wan port. As far as the static settings go you would simple configure the port with one of the ip's, it will make you restart the router and when it comes up it will have the ip that you assigned to it. I will look around to see if i can find any screenshots so i can say for sure.
     
  3. vpnuser

    vpnuser LI Guru Member

    You could use the 1-to-1 NAT on RVL200 with firmware v1.1.7. The GUI is like RV042's 1-to-1 NAT.
     
  4. ifican

    ifican Network Guru Member

    Nice little feature indeed, they need to implement that in other devices as well.
     
  5. TazUk

    TazUk Network Guru Member

    You can see the UI's of the various Linksys routers here, but for some unknown reason they've left the RVL200 out :rolleyes:
     
  6. Toxic

    Toxic Administrator Staff Member

    afaik it is on the cards to create the UI for the RVL200 but for some reason it has still yet to be finished.
     

Share This Page