How to get into Failsave mode 54g v2?

Discussion in 'Other Linksys Equipment' started by Deleted member 11179, Apr 9, 2006.

  1. Hello,

    I have got a wap54g with OpenWrt installed (WAP54GHowto). I installed it to get a backup of the configuration-files "/etc". Then I created an image using the ImageBuilderHowTo.
    It worked fine.

    But how to get the access point into the failsave mode, to flash the new firmware? I found a howto on freifunk.net, I should hold the reset-button up to blinking the LED's in front of the ap. But it did not work.

    I'm still able to login via telnet, but there is no way to write on /etc.

    This method does not work. At first you have to set up a root password, but this is impossible (ro-fs).

    Thanks!
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice