How to modify VP/VC settings WRT54GL

Discussion in 'HyperWRT Firmware' started by yves, Oct 12, 2006.

  1. yves

    yves Network Guru Member

    Hi all, I have a WRT54GL running Hyperwrt THibor 15c, next week they will upgrade my adsl2+ towards VDSL , as the router installed by the provider is very limited (NAT limited for 4 devices) and very poor wireless performance, I always putted my adsl modem/router in bridged mode and let the linksys send out the Ppoe. Much easyer instead of 2 times doing NAT... I already figured out how to bridge my VDSL modem/router , I cant modify to much, I also have other VLAN's on the vdsl modem used for IPTV, they always use bridged mode. Now the problem : ADSL alsways uses 8/35 VP/VC, but I have seen my provider uses 0/62 VP/VC for VDSL. How to modifie this in the Linksys router so I do not have to change the complete setup ?
     
  2. Thibor

    Thibor Super Moderator Staff Member Member

    VPI & VCI settings are modified within the modem, not the router.
     
  3. yves

    yves Network Guru Member

    So the VPI/VCI settings have nothing to see with the router side, only the modem, also when I let the WRT54GL doe the Ppoe authentification ?
     
  4. Thibor

    Thibor Super Moderator Staff Member Member

    you can let the router perform the pppoe if you wish, that is how i prefer it personally, or you could let the modem perfom all dialing functions and work in a half-bridge mode to pass the public ip to the router, if your modem has that capability. it's a matter of personal choice.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice