1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

How to reset stats?

Discussion in 'HyperWRT Firmware' started by callous, Mar 22, 2006.

  1. callous

    callous Network Guru Member

    Is there a way to reset the statistics for: LAN (rx/tx), WAN (rx/tx),
    eth0 (rx/tx), imq0 (rx/tx), imq1 (rx/tx),vlan0 (rx/tx), without resetting the Uptime?

    I am using Thibor14, and have no problems using telnet etc.
     
  2. Toxic

    Toxic Administrator Staff Member

    Reboot?
     
  3. callous

    callous Network Guru Member

    Wouldnt that kill the uptime.. I just wanted to see how long it takes before Bittorrent apps forces me to do a reboot!
     
  4. Toxic

    Toxic Administrator Staff Member

    dunno then m8, however i dont understand your methods. if you require a reboot due to bittorrent apps, you'lll most likely not be able to logon to the stats page anyhow as the WRT54G/gs would have locked upand therefore stats would not be relevant would they not.
     
  5. Thibor

    Thibor Super Moderator Staff Member Member

    i'm not certain, but i think you should be able to delete /tmp/.ifstat
    that should zero your stats
     
  6. rshakin

    rshakin Network Guru Member

    I can't even get the status to display properly... as i posted before, i know the tofu 13c was working just fine but when I upgraded to thib the status page now shows only part of the traffic and hasnt updated in a while... still shows the current cpu and speed but not the right ammount of data. Any ideas, is there difference between how thib and tofu implement the status page ?
     
  7. Thibor

    Thibor Super Moderator Staff Member Member

    there are ZERO differences in how the 2 versions inplement the status page, in fact they are the very same page(and code)
     
  8. rshakin

    rshakin Network Guru Member

    yeah i know now i actually downloaded the sorurce and looked at the code my self... so thanx thib
     

Share This Page