How to set smaller MTU for upstream direction ?

Discussion in 'Sveasoft Firmware' started by zolf, Aug 3, 2004.

  1. zolf

    zolf Network Guru Member

    Hi,

    I am using wrt54g (with satori) and cable modem (SB4100E). I turned on built-in BW management (wondershaper based), but i am not staisfied with granularity delay caused by 1500 MTU in upstream direction.
    Can I force lower MTU value only for upstream (about 500 bytes would be fine) ?
    If yes, will the cable modem "desegment" IP packets and remove (possible) positive effect ?

    zolf
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice