How to unlock a PAP2

Discussion in 'General Discussion' started by mrdude, Jul 11, 2005.

  1. mrdude

    mrdude Network Guru Member

    Here's some interesting info if you have a PAP2

    Open the box to find a two pin jumper for three pins available on the board. Keep the device ON, (Use a NONSTATIC gloves) unplug the jumper from the second and the third pins and connect it to the first and second pins. Punch in "****" and "FACTRESET" and then "1" on the telephone connected to the PAP2. It should announce that it's RESET successfully. Then switch off the PAP2 and revert the jumper back to its second and third pin position and close the box. That should be the PAP2 unlocked.

    Laters... :D
  2. Anonymous

    Anonymous Guest


    alguien puede decirme como desbloquear un pap2 que fue bloqueado por iconnecthere
  3. mazilo

    mazilo Network Guru Member

    Where would the 3-pin connector (switch name) located? I looked at my newly bought PAP2 (system ver3.3) and did not see any 3-pin connector.
  4. lmrodrigues

    lmrodrigues LI Guru Member

    Is it works??? I will try an put here the results.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice