How to use wag200g as access point

Discussion in 'Other Linksys Equipment' started by gubton, Aug 2, 2008.

  1. gubton

    gubton Guest

    Hi I'm a newbie in wag200g ( just brought for 1 day )
    Please suggest me following this question :
    1. what's annex a, annex b , how to know that ?
    2. Is it posible to manage bandwidth on wag200g ?
    3. How to use wag200g as access point from dsl modem zyxel 660H-T1 ?

    Thanks ,
  2. HiSpeed

    HiSpeed Network Guru Member


    1. AnnexB is for DSL on ISDN line...
    2. QoS menu...
    3. No way (no WAN port) !
  3. satmovi

    satmovi Guest

    original firmaware

    my problem is that I've just switched from my adsl provider, to a new one, without adsl and I want to use the wag200g as an wireless access point.
    I don't know where I should run this commands that you specify. I have the feeling that you're not using the original firmware. I found this woytekm firmare( but I'm not sure how to replace the original one.

    It would be great if you can help me. Thanks a lot!
  4. arturxsilva

    arturxsilva Addicted to LI Member

    I have tried to send the router some commands via putty but....

    wag200g:~#/usr/sbin/pppd-2.4.4 plugin /lib/ eth0 user $user password $pwd nodetach defaultroute usepeerdns ipcp-accept-remote ipcp-accept-local lcp-echo-interval 15 lcp-echo-failure 3 mru 1492 mtu 1492& > /dev/null
    wag200g:~#-sh: /usr/sbin/pppd-2.4.4: not found
    /usr/sbin/pppd-2.4.4: not found

    It fails :(
    Please replyn to the following post
    I'm sorry for double posting :(
  5. Linek

    Linek Networkin' Nut Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice