how to use wl cmd

Discussion in 'General Discussion' started by kooljd, Feb 17, 2005.

  1. kooljd

    kooljd Network Guru Member

    Hello,
    I am trying to do the wl cmd to change my WRT-54g Version 1.1 with Firmware 3.01.3 hyperWRT-2.0b4. Iam trying to change my router to client mode, but not sure how to do it correctly. I tryed to type type wl in the command shell.

    So i'm sure a few of you will get a laugh out of this simple question.


    Thanks for any help

    kool james!
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice