HyperWAP upgrade and previously save WAP54G config file

Discussion in 'HyperWAP Firmware' started by julioros, Feb 4, 2005.

  1. julioros

    julioros Guest

    once the HyperWAP firmware is loaded and factory defaults are set. Can I load a previously saved config file that has all the other setting on it [mac address list etc.] and then proceed to change the additional settings Hyperwap provides and the resave the updated config? :roll:
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice