HyperWRT Upgrade now "Blinking Pwr Lit"

Discussion in 'HyperWRT Firmware' started by wmclaren, Mar 29, 2005.

  1. wmclaren

    wmclaren Network Guru Member

    Hey all,
    Flashed my WRT54GS V1 with the newest from HyperWrt and now can ping the router, ether works but no wireless and can not access via web or Telnet.

    Have put in my old 11b, we back on but what to do with the 54GS?

    Help if you've ideas...can the eprom be reset?...reset on back has no effect.

  2. howardp6

    howardp6 Network Guru Member

    What firmware were you using before you put HyperWRT on your WRT54GSv1.
    You should have done a reset to Factory Defaults before flashing the firmware. Try a hard reset to restore to factory defaults. If there was a autoupdate for the linksys firmware I would have suggested you use it. You can try to tftp the Linksys firmware to the address of the router, but I would try to do a hard reset first.
  3. wmclaren

    wmclaren Network Guru Member


    Thanks for the reply. Finally got it to accept the firmware by cold booting then immediately TFTP'ing the new firmware.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice