I can't connect my WAP54 v3.1 after reflash

Discussion in 'Other Linksys Equipment' started by akoscomp3, Jan 5, 2007.

  1. akoscomp3

    akoscomp3 LI Guru Member

    I have installed in my WAP54G v3.1 DD-WRT 2.3 firmware and after I reflash the original Lynksys firmware "LinksysWAP54G-Cisco-EU-EN-3.05.03", I can't connect to my Access Point. The IP address before reflash have 192.168.10.203, but I try to connect 192.168.0.1, 192.168.1.1, 192.168.0.254, 192.168.1.254, and in linux with fping command I ping all IP address in range: 192.168.0.1-192.168.10.254.
    I try to reset, to power on when I push the reset button, I set the defaut gw 192.168.1.1, and I ping it, but not responding.
    The Wireless SSID is set linksys before reflash, and I can connect the AP, but don't know how to discover the IP address.
     
  2. TRASTARO

    TRASTARO LI Guru Member

    Yo despues de aplicarle RESET conecte directamente el WAP54G a la tarjeta de red de la PC, configure como Gateway la IP del WAP54G y después pude hacer ping al Acces Point. Ya es como respondio y despues pude conectarlo de nuevo al router y usar el SetupWizard para el firmware nuevo.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice