I need to make a trunk between Cisco switch and tomato

Discussion in 'Tomato Firmware' started by netgus, Nov 13, 2012.

  1. netgus

    netgus Serious Server Member

    Hello,

    I need to make a trunk between Cisco switch and tomato and I can not do.


    interface GigabitEthernet1/0/6
    description Trunk with the Linksys E3000
    switchport trunk encapsulation dot1q
    switchport trunk native vlan 8
    switchport trunk allowed vlan 8
    switchport mode trunk
    switchport nonegotiate
    end

    The port 1 is tagged and normally, it should be ok.

    Someone can help me to understand where is my problem

    Thank
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice