I/O error

Discussion in 'Cisco/Linksys Network Storage Devices' started by silent-one, Jul 24, 2005.

  1. silent-one

    silent-one Network Guru Member

    I recently purchased an NSLU2 and when it works, I like it. However, I am having a very difficult time copying files/folders to the drive. I will start to copy a folder with several gigabytes worth of data. The copy will start with no problem and then after seeral minutes I get the following error message.

    "unable to create or replace 'folder name'. The request could not be performed because of an I/O device error."

    Any idea as to the cause and/or a cure.
     
  2. u3gyxap

    u3gyxap Network Guru Member

    I had the same problem. It appeared that the hard drive was deffective. Low level format didn't help. Replased it and it was all good after.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice