1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

info wrt300n

Discussion in 'DD-WRT Firmware' started by clabit, Sep 19, 2006.

  1. clabit

    clabit LI Guru Member

    hallo
    I have wrt300n v1 us. I can upgrade firmware with dd-wrt.v24_mini_generic.bin?
     
  2. eric_stewart

    eric_stewart Super Moderator Staff Member Member

    Yes you can. I flashed that firmware to my WRT300N v1. It seemed to work fine with a notable exception. This was over a month ago but I seemed to remember an issue with the wireless not working properly since MIMO wasn't correctly implemented according to the firmware's author, Brainslayer. You might want to check that out but I can at least guarantee that you won't brick it if you follow the instructions found in the release notes and readme.

    /Eric
     
  3. clabit

    clabit LI Guru Member

    thanks in order to have to me answered.
    my problem is to use pc card Pci wireless eu with this router wrt300n v1 us.
    if I use this firmware do I resolve my problem?
    could you suggest me something?
    thank you
    Claudio
     
  4. Ayala

    Ayala LI Guru Member

    what about WRT300n v2?
    it's upgradable too other 3rd part firmwares?

    Ayala
     
  5. Toxic

    Toxic Administrator Staff Member

    what firmwares support the v2? afaik it is NOT upgradeable since it runs on an Atheros chipset and no 3rd party firmware is based on this chipset as yet.
     
  6. clabit

    clabit LI Guru Member

    i have done software upgrade the firmware dd-wrt.v24_mini_generic.bin but
    the router dosen't work
    could you suggest me something?
    thank you
    Claudio
     
  7. eric_stewart

    eric_stewart Super Moderator Staff Member Member

    Can you be more specific? You said it "doesn't work" but does that mean that you can't access it at all, or it doesn't route.....what exactly?

    One thing you should be aware of (it's in the release notes) is that the default username becomes "root" versus "admin" to administer the device.

    /Eric
     
  8. clabit

    clabit LI Guru Member

    to get in router i don' t use username and the password that i use is admin, but it stops at 6 % and it says error.
    if i upgrade with original firmware 0.93.3 it ' s alright.
    What I have to do to use my router with pci wireless eu???
    thanks
    Claudio
     
  9. eric_stewart

    eric_stewart Super Moderator Staff Member Member

    You must be describing the firmware upgrade procedure. You should reset the device to defaults by using the reset button in the back, *then* perform the firmware upgrade. Once that has completed you should (again) do a hard reset before attempting to configure the device.

    /Eric
     
  10. clabit

    clabit LI Guru Member

    ok i have upgrade the wrt300n
    firt i upgrade dd-wrt.v24_mini_generic.bin and then dd-wrt.v24_generic.bin
    i now it works.... finally!!! and now i have got 14 channels.
    thanks you
    Claudio
     
  11. eric_stewart

    eric_stewart Super Moderator Staff Member Member

    Enjoy your router. We might as well embrace the new WRT300N series because, like it or not, the WRT54xx series are going the way of the Dodo soon.

    /Eric
     
  12. magnus33

    magnus33 Network Guru Member


    Iam guessing thoguh you have 14 channels none of them acutally work.
     

Share This Page