1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Installation guide for Tomato firmware on a Buffalo router

Discussion in 'Tomato Firmware' started by der_Kief, Jun 5, 2007.

  1. der_Kief

    der_Kief Super Moderator Staff Member Member

  2. GeeTek

    GeeTek Guest

    Nice find Der Kief, but that is really the "slow boat to china" method. Jon's buffalo flasher batch file has a lot of advanced DOS commands in it, and has never missed a single time. I use it with no hub between the PC and radio. I have had the Tftp automated utility time out on me a few times with no hub, but not the batch file. It is still 100% successful (out of a good 40 or so flashes). Options are always good though !
     
  3. Talon88

    Talon88 LI Guru Member

    :::

    Jon's buffalo flasher batch file

    Save the codes as .bat file & run together
    with the firmware file.

    :::

    Code:
    @echo off
    echo ===========================================================================
    echo This batch file will upload TOMATO.TRX in the current directory to
    echo 192.168.11.1 during the router's bootup.
    echo.
    echo * Set your ethernet card's settings to:
    echo      IP:      192.168.11.2
    echo      Mask:    255.255.255.0
    echo      Gateway: 192.168.11.1.
    echo * Unplug the router's power cable.
    echo.
    echo Press Ctrl+C to abort or any other key to continue...
    pause > nul
    echo.
    echo * Re-plug the router's power cable.
    echo.
    echo ===============================================================================
    echo Waiting for the router... Press Ctrl+C to abort.
    echo.
    :PING
    ping -n 1 -w 50 192.168.11.1 > nul
    if errorlevel 1 goto PING
    echo tftp -i 192.168.11.1 put tomato.trx
    tftp -i 192.168.11.1 put tomato.trx
    if errorlevel 1 goto PING
    echo.
    echo ===============================================================================
    echo * WAIT for about 2 minutes while the firmware is being flashed.
    echo * Reset your ethernet card's settings back to DHCP.
    echo * The default router address will be at 192.168.1.1.
    echo.
    pause
    
     
  4. fastpakr

    fastpakr Network Guru Member

    Um... isn't that already included with the firmware download? What's the point in copying and pasting it separately?

    I'm probably missing something.
     

Share This Page