1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Intentification of the wrt54gs interfaces for fwbuilder

Discussion in 'Cisco/Linksys Wireless Routers' started by Gheimposse, Jan 16, 2005.

  1. Gheimposse

    Gheimposse Network Guru Member

    I like to define my own rules for the firewall builder (www.fwbuilder.org).
    To get an indeep definition I like to address the interfaces itself i.e. wlan and lan in two different rulesets so that I can restrict access from wlan to webmenu and lan interface, etc.
    At Seattlewireless I found the following screenshot.

    (__br0___)
    / | \ \ \_______
    / | \ \ \__
    / | \ \ \
    | [0] [1] [2] [3] [4] | | [wlan] |
    | vlan1 ---- vlan0 ---- | | |
    | WAN LAN | | WLAN |
    | | | |
    |Internet 1 2 3 4 | | WLAN | <-- label
    +-------------------------+ +--------+
    ethernet switch wireless
    eth0 (cpu port 5) eth1

    Believing this documentation the br0 shares the lan (vlan0) and the wlan (eth1).
    Eth0 itself is the wan uplink (vlan1) including the four switched ports (vlan0).
    Now I need some help how to setup the interfaces as well as how to setup the ip-addresses for the interfaces.

    May anyone support me with the hardfacts?
     

Share This Page