1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ip/mac bw limiter missing on RAF tomato-E3000USB-NVRAM60K-1.28.9007?

Discussion in 'Tomato Firmware' started by ChaosBlades, Dec 25, 2011.

  1. ChaosBlades

    ChaosBlades Networkin' Nut Member

    I'm new coming from DD-WRT wanting a ip/mac bw limiter for my Linksys E3000. After some reading and searching TomatoRAF should have a ip/mac bw limiter but I do not see it in the latest version that I found on the http://victek.is-a-geek site version "Tomato RAF 1.28.9007."

    I have seen pics on where it should be but it is not there. Do I need to enable it or is it just not on this version? What firmware (link plx) should I be using exactly to accomplish this on my E3000?

    Exact filename of current firmware is...
    tomato-E3000USB-NVRAM60K-1.28.9007MIPSR2_RAF-VPN-NOCAT.bin
     
  2. ChaosBlades

    ChaosBlades Networkin' Nut Member

  3. fubdap

    fubdap Addicted to LI Member

    Do NVRAM erase. If that did not solve the problem. I would suggest you down load a new file from the website.
     
  4. ChaosBlades

    ChaosBlades Networkin' Nut Member

    Thanks, but it did not work. I did NVRAM erase and it is not there. I then downloaded and installed it again with NVRAM erase and it still was not there. I then did NVRAM erase again with no luck. It is an option between "QoS" and "RAF Features" that says something like 'IP/MAC BW Limiter' correct?
     
  5. fubdap

    fubdap Addicted to LI Member

    Yes
     
  6. ChaosBlades

    ChaosBlades Networkin' Nut Member

    I got it to work. I downloaded rev 9006 which is about .5MBs smaller than build 9007. I clicked on RAF Features and it was a menu that dropped down from that option. Makes me think it was there all along and I just didn't see it.

    http://victek.is-a-geek.com/Repositorios/TomatoRAF/
     

Share This Page