IPSEC tunnel & CPE

Discussion in 'Networking Issues' started by binary_dreamer, May 4, 2011.

  1. binary_dreamer

    binary_dreamer Networkin' Nut Member

    Hi.
    I am new to the forum so i am not sure if this is the correct section to post.

    there is a company having 3 remote installations. each office has a DSL connection with a block of ips (/29). Due to the fact of implementing voip on the router it is not possible to change it to something else. so i would like to each of offices to get a wan router to talk point to point through the /29 subnet to the ISPs router. In that wan router i would like to setup an IPsec tunnel to the main office.

    all of the offices have the same setup.

    up to now i have had ciscos 877 and i have created two vlans in each cisco. one vlan for the point to point and the other vlan for the inside lan. then i created an ip sec tunnel using of the /29 ips. is there a way to use a much cheaper cpe such as wrt54 or any other?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice