1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

IPSec tunnel from WRV54G to m0n0wall

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by hatfulofhollow, Apr 11, 2006.

  1. hatfulofhollow

    hatfulofhollow LI Guru Member

    I have two sites that I need to connect (obviously). A main site with local addresses in the 192.168.100.0/24 range and static routes to a slew of other sites needs to connect to a remote site with local addresses 192.168.222.0/24

    At the remote site with the linksys WRV54G I have configured the local subnet as 192.168.222.0/24 and the remote subnet as 192.168.221.0/24. On the m0n0wall box I configured 192.168.221.0/24 as the local group and 192.168.222.0/24 as the remote. I matched up all of my keys and encyption algorithms. I hit connect and the WRV54G says it's connected. I check the m0n0wall logs and I see the handshake and that the devices are apparently now connected.

    This is where I start to get confused. I still have no connectivity between the sites and I assume this is due to a routing issue (maybe). What do I need to check to make sure everything is working properly? And If I'm missing a route where does it need to go (in one gateway? in both?) and what exactly does the route need to be?

    Thanks in advance
     
  2. TazUk

    TazUk Network Guru Member

    So you can't ping the monowall from the Linksys end or vis versa?

    OT: I take it your a Smiths fan :)
     
  3. hatfulofhollow

    hatfulofhollow LI Guru Member

    Exactly. If I try to ping an address on the main site I see the packet just completely avoid the tunnel and go out through my regular internet connection before being lost in oblivion.

    And yes.
     
  4. TazUk

    TazUk Network Guru Member

    If that's the case then the tunnel hasn't be initialised or has been closed.

    What browser are you using to setup the WRV54G?

    What firmware version is the WRV54G running?
     

Share This Page