1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

IPv6 (native) on Toastman TomatoUSB (latest)

Discussion in 'Tomato Firmware' started by zurk, Nov 7, 2013.

  1. zurk

    zurk Addicted to LI Member

    Tomato Firmware v1.28.7503 MIPSR2Toastman-RT K26 USB Ext
    I am running native ipv6 dual stack with SLAAC from the ISP and the router gets a SLAAC address.
    It can ping ipv6.google.com fine from the Tools - ping tool. Connecting windows or linux boxes on the wan side allows them to browse ipv6 websites and ggets a 10/10 on the test ipv6 website.
    I have announce ipv6 on LAN checked, Accept RA from WAN checked and Native IPv6 from ISP with everything filled in but none of the LAN boxes can ping ipv6.google.com and they all get 0/10 on the test ipv6 tool. Any ideas ?
    Also is there any way to build a correct ipv6 route from the command line if it is not possible via the gui ? i can ssh into it.
     
  2. tricky89

    tricky89 Reformed Router Member

    You're not only one.. Native IPv6 from isp seems to be broken. ANYTHING on lan side will hit router as first hop then go no where. If I configure it has DHCPv6 with prefix delegation windows hosts work OK, linux ones seem to work for a bit then stop working.

    I have no problem getting it working fine under debian vm.. ppp0 gets dynamic /64 from internode and I've manually setup my routed /56 to eth0 and radvd is announcing to my network fine and I can browse/traceroute as I should..
     
  3. zurk

    zurk Addicted to LI Member

    nevermind i fixed it.
    Enable Native IPv6 on the ipv6 config page, disable/leave everything blank except check off accept RA from wan. do NOT tick enable RA and do NOT fill in any subnet info.
    then go to admin - scripts - wan up and do :
    ebtables -t broute -A BROUTING -i vlan2 -p ! ipv6 -j DROP
    brctl addif br0 vlan2
    on your windows boxes you will need to do :
    netsh interface teredo set state disabled
     

Share This Page