JTAG PINOUT on WRT54G 1.0

Discussion in 'Cisco/Linksys Wireless Routers' started by gentlemanRT, Nov 14, 2005.

  1. gentlemanRT

    gentlemanRT Network Guru Member

    Hello,
    i have build a JTAG Cable yesterday. (The one with the four 100 Ohm Resistors) But it did not work. I still get FFFFFFFFFFFFFFFF when i try to access using the wrtjtag tool. I´m not sure if i used the correct pins on the JTAG Connector J2 on my WRT54G Hardware 1.0 (the one with the mini pci). Do someone know where pin 1 is (its not marked) and how to count it?

    Thanks
    Alex
     
  2. Toxic

    Toxic Administrator Staff Member

  3. crawdaddy

    crawdaddy Network Guru Member

    I had the exact same problem, but with a v3 WRT54G. Still can't figure out what I can do. I was trying to load up a beta of dd-wrt on mine...
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice