Lan Failover?

Discussion in 'DD-WRT Firmware' started by Pyromanci, Apr 28, 2009.

  1. Pyromanci

    Pyromanci Guest

    I see articles and several wiki tops for a redundant WAN setup for the DD-WRT firmware, but i was wondering if the same thing could be done on the LAN side.

    See i have 2 servers right now that are doing preforming a network base raid 1 setup. I have serial cable based heartbeat process monitor failover setup, but I know this wont catch all the possible problems. So I have trying to figure out the best way to also handle network failure.

    Would there be any way to set somthing like this up with the dd-wrt firmware?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice