Lan full duplex

Discussion in 'Cisco/Linksys Wireless Routers' started by Phil06, Dec 25, 2004.

  1. Phil06

    Phil06 Network Guru Member

    Hi men merry christmas

    I have a question i use a router Linksys WRT54G v2.0
    I have 2 pc connected to the router by 100Mb cards (1 Nvidia of my mother board Asus A7N8x deluxe rev2.0 and on the second pc the adapter is a Dlink DFE 530TX)

    When i work in half duplex it's ok but when i want to set in full duplex the lan connection become really slow (under 5% of the max bandwith)
    I had try few differents firmwares but it's same.
    Actually i use the HyperWRT 2.0b3 with QoS active
    I have 2 lan adapter on the Asus and i had try with both and it's not better

    I must to precise that the lan full duplex works really fine without WRT54G with a "cross link" (not sure of the word)
    My WRT54G have a prob?
    On the box it's write: Full duplex 4 ports 100Mb


    Other question the Wan port is 10Mb/s or 100Mb/s because the new connection are faster than 10Mb/s

    Sorry for my bad english
    Thx for your help

    Have a good day @+
     
  2. Morpheus

    Morpheus Network Guru Member

    10Mb/s on the WAN

    Merry Christmas to all :wink:
     
  3. Toxic

    Toxic Administrator Staff Member

    try different drivers for the lan cards and check you cables are CAT5
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice